福州附近有没有服务

The reasons for poor pasting effect of waste paper packer are: too high or too high temperature

    Waste paper packer The reason for poor paste effect is: the temperature is too high or too low. If special belts are used, the viscosity is very poor and the temperature is very accurate. Probably not enough voltage. To use expansion cables, you need to use thicker cables continuously and use longer cables incorrectly. The sliding bearing under the knife in the packer may break, which will lead to hot and cold, but never stick.
The long tension spring on the electric heating rod of waste paper packer is damaged, because it is difficult to clap hands and pull unexpected hands to the column, or poor adhesion; the whistle of the electrical steel plate of the packer is not correct, high or low, too right, too high and too low will impact the upper and lower PP belts, and the horizontal and vertical will touch the left but not return to the original position It is not allowed to enter the heating system, which should be expanded and adjusted according to the specific situation; the following packer (such as the micro electric fan that produces cloud) was born. Failure can cause excessive temperature, which can submerge the immersion loading function.
The waste paper packer keeps feeding due to the fault of belt potentiometer (such as replacement); if the button is changed, the green button or other faults will appear on the belt button; if there is no bundling, it will be disassembled; if it is tightened, the debugging flexibility of the automatic baler is too large; the whistle position of LS3 and ls5 of the automatic baler is not appropriate; the whistle position of LS3 and ls5 of the automatic baler is not appropriate; The automatic packer switch with electromagnetic induction is faulty.
In the use of waste paper packer, there are many problems in the packaging of waste paper packer, so we need to be careful when using waste paper packer. In the control system of the packaging machine, when the control box cover is opened on the circuit board, the adjustment knob can not be seen, and the net increase of temperature regulator in clockwise direction is as usual. If the temperature is too high or too low, the adhesion is not good, so don't transfer too much at a time, it seems to move in scale 4-5. If the power supply voltage of waste paper packer is abnormal, it should be converted to 220 v. These plant voltages are usually low. Even if the soup head is tightened long, the voltage will not drop if the motor is used.
The power level of the waste paper packer and the priority of the requirements of the system on the performance of the working machinery. First, specify the hydraulic pump kit, and then determine the priority of the mold based on the pressure required by the system. Basically, gear pump and double vane pump can be selected in automatic baler with light load and low power level.
 

Last article: Parts of waste paper packer will be damaged due to collision during operation, and the seal will be scratched

Next: How does the hydraulic packer work