Waste paper packer Attention should be paid to the antifreeze operation and long-term overload of the motor. Effective prevention of these two items can greatly reduce the damage of the motor, thus maintaining the normal packaging of waste paper packer. Due to the existence of dust and impurities in the design environment of waste paper packer, it is necessary to select a suitable dust-proof gasket in the design to prevent dust and other dirt from entering the system, thus damaging the gasket and polluting the engine oil, resulting in leakage. The cylinder seal of waste paper packer is made of oil resistant rubber and other materials. Due to long-term use, aging, rupture and damage can lead to system leakage.
If the parts are damaged due to collision during the working process, the seal will be scratched, which may lead to leakage of waste paper packer. The reason why the motor of waste paper packer vibrates strongly during operation is that the motor is not consistent with the mechanical center it drives. The coupling fails; the unit is out of balance and the foundation is not firm. In the case of the same packaging quality, 50% power saving can be achieved, which greatly saves the electricity charges of customers in the packaging station. At present, the machine has been put into the market and the effect has been verified. The seal of waste paper packer must be selected from famous brand with high quality. Only good seals can delay the aging of seals.
In the hydraulic system of waste paper packer, the working fluid is not only used to transfer energy, but also has smoothing effect on the surface of hydraulic components. In some machine tools, the smooth system oil source of the machine tool comes from the hydraulic system, and the hydraulic system uses the same oil pump to supply oil. Therefore, in the range of working temperature and pressure, hydraulic oil should have high oil film strength and excellent smoothing function to avoid drying conflict.
After the waste paper packer starts to pack, it cannot feed paper normally. You need to check the operation panel of the waste paper packer to see if the potentiometer is faulty. Clean and free of impurities. If there is moisture, it will reduce the waste paper packer. The wrapping tape of waste paper packer cannot be bonded properly. At this point, two places need to be checked. One is the conveyor belt path, which can be adjusted to the appropriate width, and the other is whether the heating plate can work normally. The smooth function of oil; mechanical impurities will block the orifice and valve plug; acid and alkali will corrode metal and damage the sealing structure. Volatile substances can thicken the oil and cause bubbles to damage the smoothness of the transmission.